WAUKESHA VALVES – W68/W88 SERIES – PRESSURE CONTROL VALVE

“Pressure Control Valve- Removing the Valve”

VALVE REMOVAL
Before detaching the port connections on the valve body, perform the following:
1. Clean, rinse and drain the pipe system elements attached to the valve.
2. Remove or block the fluid and gas lines to prevent material from entering the pipe system elements attached to the valve.
3. Shut off the delivery of the control air unless it is required for the removal of the valve stem/actuator assembly from the body.
4. Disconnect the electrical supply and lockout all power.
5. If the valve has a control module with solenoid, the air and electric supply must remain ON until the valve is properly disassembled.

 

*See SPX manuals on W68/W88 Pressure Control Valve located under the Manuals tab